These low profile P.O.I..® (Precision Optics Interface) Rings have a 23mm center height to fit optics with a 1" tube and up to a 45mm outer objective. Leaper’s innovative P.O.I..® rings address three of the most critical scope ring requirements. First, they are progressively machined for a precise inner diameter scope interface to achieve a seamless ring-to-scope interaction. Secondly, the low profile, flush-fitting locking side plate controlled by dual spring-loaded guide rods interfaces with the rail with Torx screw locking to ensure secure and repeatable zero hold. Finally, the square-shaped integral recoil stop interfaces with a Picatinny slot via complete surface contact to eliminate the possibility of forward and aft movement from recoil vibrations. Each ring in the two-piece set is equipped with 4 Top Torx Screws and designed with a 22mm ring width. The rings are designed to fit on Mil-spec 1913 Picatinny Rail platforms. They are machined from 6061-T6 aluminum alloy and 4605 steel with a matte black hard coat anodize finish. Note: vendor recommends tightening the ring top screws with a torque value of about 25 inch-lb. and the side plate screw with torque value of about 45 inch-lb. Sold as a set of two rings only. Made in the USA by Leapers®, Inc.
0
WARNING: This product can expose you to chemicals including
lead, which is known to the State of California to cause cancer and birth defects
or other reproductive harm. For more information go to -
www.P65Warnings.ca.gov.
