|
 |
 |
Wish I could buy |
6/26/2024 |
| Would buy if there was at least a link to the mounting hardware. Not a big ask. |
| - Mark Webb, FL |
| |
|
Mounting Screws |
2/8/2024 |
| No screws, really. Makes doubt Rugers commitment to customer service. |
| |
 |
Zeroing difficulty |
2/2/2024 |
| Many have trouble zeroing with replacement sights. I did and it is because of the poor quality control at Marlin when Remington owned them. The barrels screw too far or not enough into the receiver. This causes the front site to cant. |
| - John Gibson, CO |
| |
 |
Worked on my rifle just fine |
12/10/2022 |
| Had to buy screws to go with it. No big deal. The sight itself works great! Exactly what I was looking for my 45-70 Trapper! |
| - Brandon Howell, OH |
| |
|
no bolts that fit....really? |
9/15/2022 |
| what a rip off |
| - Claude Judd, TX |
| |
|
Close but no bullseye.. |
9/1/2022 |
| Bought this on the advice of Ruger to replace the front ramp on my 45/70 . Good visibility - but it cost me another 18 bucks including shipping to get the mount screws since I found out after receiving that I needed them. .. and it was off both center and height. I couldn’t get it within 14” of the bullseye at 50 yards. Ran out of adjustment room. I almost gave it 2 stars just because it does show up.. |
| Jim Fleet |
| |
0
WARNING: This product can expose you to chemicals including lead,
which is known to the State of California to cause cancer and birth defects or
other reproductive harm. For more information go to
www.P65Warnings.ca.gov
